- Securityspy applescript for mac os x#
- Securityspy applescript movie#
- Securityspy applescript software#
- Securityspy applescript mac#
Please see the file /Applications/VideoGlide/VideoGlide Tools/VideoGlide Toggle Audio ReadMe for more information about this problem and some possible solutions. But it can also happen when using a non-native, emulated PowerPC application on Intel-based equipment with a device that has audio inputs. This is usually the result of unplugging the device while using it, or trying to connect to the device while it is use by another application. Under some circumstances, it may be desirable to deliberately record movies at the largest natural size, and then use VideoGlide Exporter to scale the movie.
Securityspy applescript movie#
Width =704 and height = 480 or height = 576 width = 352 and height = 240 or height = 288 width = 176 and height = 120 or height = 144 width = 88 and height = 60 or height = 72 However, if the option key is held down while opening the movie, any movie can be made 4 to 3. Examples: Open the application /Applications/AppleScript/Script Editor. If this parameter is not specified, the movie will be recorded until stopped. start recording duration 20 Specifies the length of time to record a movie in seconds. If this parameter is not specified, the current frame size is used. If the digitizer supports it, take the largest picture possible. After clicking "OK" you will be asked to specify the name of the movie file to save. Clicking "Video Settings…" will open the Video Settings dialog where the format of the movie file can be specified. You can set the playback frame rate using the "Movie playback rate" field. You can optionally specify the length of time over which to capture frames. Use this option to capture a frame of video every few seconds. The recommended choice is "Off While Recording". In addition to the three panels described above, the following sound settings are always available on the right hand side of the Sound Settings dialog: Speaker menu: Controls when sound is played.
If data size is critical, lower quality settings can be used. Rate menu, Size, Use: Choose the highest rate, 16 bits and Stereo for general use. Format menu: This menu lets you choose between the PAL, SECAM or NTSC standards. However, if you have active video sources attached to both the s-video connector and the composite connector, it will be necessary to use this menu or sub-list to choose between them.
Securityspy applescript software#
The VideoGlide software is smart enough to auto-select the input if there is only one active video source. Input menu or sub-list: This lets you select which input to digitize from: s-video or composite. Frames per second: Leave this blank to capture the maximum frame rate possible for your video standard.ĭistinguish them. Higher quality results in bigger file sizes, "cleaner" video and lower frame rates. Lower quality results in smaller file sizes, "noisier" video and higher frame rates. The lower the quality setting, the higher the compression rate. Quality: This setting affects the compression rate of the incoming video frames. You can optionally specify the length of time over which to take snapshots. Use this option to take a snapshot every few seconds. This option is unnecessary, and is not available for most digitizers. Reconfiguring the device is time consuming, so the video frame that is captured will be one that occurs one or two seconds later. The device is reconfigured and a high quality, "large" snapshot is taken. Certain devices offer a large snapshot mode.
Securityspy applescript for mac os x#
VideoGlide For Mac OS X 1.4 5/28/12 Contents QuickStart Introduction System Requirements Installing the Software Connecting the Digitizer Video Sources Using VideoGlide Capture Using VideoGlide Exporter VideoGlide and Third Party Software Using Multiple Devices Trouble-shooting Contact Information QuickStart Use these steps to start capturing quality video right away.
0 kommentar(er)
